program not started when vehicle arrived

level 1 service
sharonyeh
posts: 43
joined: tue mar 29, 2016 3:17 am

program not started when vehicle arrived

postby sharonyeh » mon jul 25, 2016 10:46 am

description:
program not started when vehicle arrived

steps to follow:
check detection status of the led d27 on the lower left corner of the terminal io control board. if no detection, press and hold on to the reset button of loop detector 1, and release the button after the vehicle leaves the detection zone. if there is detection, then check terminal system program status. power cycle the embedded system control board for 3 seconds if needed.

return to “troubleshooting steps”